Idiomas disponibles
Idiomas disponibles
Install new lock on the new door
To install this product on a new door, please go through the following steps to drill the hole.
Identify Door Handing
Before installing this product, please confirm the door opening direction to make sure that the
lever is installed in the correct direction.
Face the door from outside, the door is left handed if the hinge is on the left-hand side of
the door, whereas the door is right handed if the hinge is on the right-hand side of the door.
Door
(Left Handed)
Check that the lever direction meets the door handing. If not, please switch the levers by
following steps.
Mark the Door with Template
Select the height and backset as desired on the door face ; use the
template as an indication to mark the center of the circle on the
door face and the center of the door edge.
Drill Holes
Using the marks as a guide to drill a hole Ø2-1/8" (54mm) through
the door face for the lockset, then a hole of Ø1" (25.4mm) for latch.
Interior
Exterior
(Right Handed)
Hinge
2
