Idiomas disponibles
Idiomas disponibles
Automatic lockup timer
Enter PC
Instruction: the timer can be set from 10 to 99 seconds.
Temporarily disable user codes
Enter PC
Instruction: When all user codes are temporarily disabled, all electronic functions will be
temporarily disabled as well. The door must be locked or unlocked manually with the key. To
restore user code functions, please repeat the setup process for "Temporarily disable user code".
Use one-time user code
Enter PC
Instruction: Once this user code is entered and used, it is disabled and unable to open the door
again. However, the same one-time user code can be set again.
Restore factory default
Instruction: After removing the batteries, touch the keypads for three seconds and re-install the
batteries. When the numbers 2, 5, 8, 0 are displayed on the keypad, press the four numbers in
any order until all numbers disappear.
CAUTION
Prevent unauthorized entry. This lock can be opened using a default user code (1234) that is set
at the factory. Upon installation and set-up, change the default programming code (0000), delete
the default user code (1234), and add the new user code prior to setting up other functions.
Since anyone with access to the power board can reset the codes to the factory default setting,
you must restrict access to the power board (including the battery pack) and routinely check the
codes to assure they have not been altered without your knowledge.
6
8
9
Enter a two-digit
number (10～99)
New UC
13
