Idiomas disponibles
Idiomas disponibles
- When the unit is to be fixed to a base or an extending support, adjust the feet (P) till it is perfectly steady, then tighten the
locknut (D) so that the foot is blocked. Subsequently fasten from beneath by way of M5 screws (T) and respective washers,
screwing them into the feet as shown in the illustration.
For units with electric oven only
Electrical connection should be performed in compliance with the CEI regulations, only by authorised and competent
personnel. In the first instance, examine the data shown on the technical data table of this manual, on the label and on the
electrical diagram.
The envisaged connection is of the fixed type. The position of the terminal box, accessible by removing the left side, is
explained, for each model, on the present manual and on the oven base itself.
IMPORTANT: Ahead of each unit it is necessary to install an omnipolar main breaker, having a spacing among contacts of
at least 3mm; example:
- manual breaker of appropriate capacity, complete with
fuse valves
- automatic breaker with respective magnetothermal
relays.
- 21 -
GB
