Idiomas disponibles
Idiomas disponibles
Change direction of door rotation (if necessary)
Attention!
◊ Never lay the product flat, this may damage the cooling system.
• Required tools: cross screwdriver, flat screwdriver, hex wrench.
• Required people: 2.
1.
Make sure the product is unplugged and empty.
2.
Tilt the product backwards so you have access to the feet. Rest the product on
something solid so it does not slip while flipping the door.
3.
Loosen the 2 screws on the back of the top panel.
4.
Remove the top panel and set it aside along with the screws.
5.
Loosen the top hinge.
6.
Lift the door and place it on a soft surface to prevent scratching.
7.
Loosen the lower hinge.
8.
Remove the legs on both sides.
9.
Unscrew and remove the pin.
10. Turn the bracket over and replace the pin on the bracket.
11. Install the bracket on the other side of the product.
12. Screw back both legs.
13. Carefully remove the door rubber, rotate it 180 degrees and press it back onto
the product. The magnetic surface of the rubber should match the direction of
the door.
14. Replace the door. Make sure the door is aligned horizontally and vertically so
that the seals are closed on all sides before permanently tightening the top
hinge.
15. Replace the top panel.
16. Screw the top panel in place with the 2 screws.
English
33
