Idiomas disponibles
Idiomas disponibles
• Turn the fan on and change the speed
until the most noticeable swing occurs
(usually the highest speed).
• Turn off the fan. Select a blade and
place the balancing clip on the edge of
it, between the holder and the tip.
• Turn the fan back on and see if the tilt
has improved or worsened. Turn the fan
off and change the clip to another blade
to check again. Repeat this process for
all blades and note which blade has the
most noticeable improvement.
• Put the clip back on the blade where
you noticed the greatest improvement.
Move the clip along the blade and turn
on the fan to find the position where the
clip offers the better improvement.
• Next, remove the clip and place one of
the balance weights on the point where
the clip was placed. To do so separate
the white sticker with your fingernails
or, if necessary, carefully use a knife or
scissors.
• Make sure the problem has been solved.
If the imbalance persists, repeat the
process. You can use light weights on
those blades that may need it.
USING THE APPLIANCE
This device is very easy to use and does
not require much knowledge. However, we
advise you to familiarize yourself with the
instructions below.
The fan has 3 power levels that can be
selected through the remote control. It also
has a timer of up to 8 hours.
Remote control:
See picture 08 on page 9.
The device incorporates a remote control,
for a more comfortable and efficient use.
In order for the remote control to work, it
must always be aimed at the fan.
Before you start using it, please take a few
minutes to familiarize yourself with the
functions:
To turn on the fan press the Low/Med/Hi
button based on the desired air flow.
14. LOW: Fan turning at minimum speed.
15. MED: Fan turning at medium speed.
16. LIGHT ON / OFF: Press this button to
turn the light on or off and to set the
color of the light between neutral,
cold and warm.
17. HI: Fan turning at maximum speed.
18. STOP: To turn off the fan
19. 2H: Setting for the fan to turn off
automatically after two hours of
operation.
20. 4H: Setting for the fan to turn off
automatically after three hours of
operation.
21. 8H: Setting for the fan to turn off
automatically after three hours of
operation.
22. 1H: Setting for the fan to turn off
automatically after one hour of
operation.
In order to be able to use the ceiling fan
through the remote control, the receptor
included with this device must be installed
before, as explained in the installation
section of this manual.
To use the remote control, you must add 2
batteries to the bottom of the remote.
If your model has LED light with different
colour tones, you can change the colour
temperature of the light by switching it on
and off with the wall switch, the remote
control or, in case of a smart fan, from your
terminal. See picture 10 on page 9.
Each
associated with the receiver
included with the fan.
When you turn off the fan with
the remote controller, the light
settings will be saved according
to the last option you selected.
For example, if the light is set to
the "warm" position when you turn off the
fan, when you turn on the fan again with
remote
control
EN
is
33
