Idiomas disponibles
Idiomas disponibles
If during a remote control recording procedure the LED of the associated relay remains on for one second and then emits a
slow double flash, a further SEED code must be sent via the remote control. This code is transmitted by several remote
controls through a hidden key or combination of keys. If you do not know the procedure or cannot transmit the SEED code,
keep pressing the remote control key that you are trying to record: it will be saved as HSC fixed code.
Keep the key pressed until saving is complete (LD1 and LD2 remain on for half a second).
16.2 DELETING A REMOTE CONTROL
To delete a remote control, press the P key (the LD1 LED will start to flash), then press the S key.
In this phase the LD1 and LD2 LEDs are both on, press the key of the remote control you want to delete and keep it pressed
until all the LEDs turn off.
The deletion has been carried out. Repeat the operation for all remote control keys you want to delete.
16.3 FULL RADIO RESET
For full radio reset simultaneously press the P and S keys for 10 seconds and keep them pressed until the LEDs flash rapidly,
then release the keys.
16.4 ERROR MESSAGES
Code not found:
The remote control you want to delete is not present in the receiver or has not been correctly interpreted. Repeat the
deletion operation.
Code memory full:
No more remote controls are accepted because the receiver memory is full.
Delete a remote control not in use and retry.
Frequency memory full:
The maximum limit of available frequencies has been reached.
The receiver's ability to store different frequencies is limited, the remote control in question cannot be stored.
17- PEDESTRIAN OPENING WITH CH2 RADIO
The B120+ control unit allows you to use the second radio channel CH2 RADIO like pedestrian opening by remote control
1- Connect the relay output (terminal 43) to ground 0V (terminal 47)
2- Connect the APP input (terminal 30) to the other relay output (terminal 44).
3- Set in the "SETTINGS MENU" -> "MONOSTABLE CH2 MODE"
4- Record the button of the radio control (see paragraph 16.1) to be used to partially open the leaf.
LD1
LD2
FLASH
ON
ON
FLASH
OFF
FLASH
DESCRIPTION
Code not found
Code memory full
Frequency memory full
17
