Idiomas disponibles
Idiomas disponibles
8- ANTENNA
Connect the antenna signal cable to terminal 41 and the ground to terminal
42 (see figure opposite).
Moisture in the walls or metal parts in the vicinity may adversely affect the
range of the system. It is therefore recommended to install the antenna as
high up as possible. Use an RB58 coaxial cable or similar (50 Ohm
impedance) with a maximum length of 5m.
NOTE: for short distances it is sufficient to connect a 17cm
piece of stiff wire for 433.92MHz frequencies, or 8.6cm for
868MHz frequencies.
9- MAIN MENU
The B120+ control unit is equipped with a display for viewing parameters and 4 keys for navigating the various menus.
To access the main menu press the SX and DX keys at the same time (see figure opposite).
N.B: access to the menu is allowed only if the control unit is not performing manoeuvres.
To scroll through the various menu items (BASIC ↔ ADVANCED ↔ SYSTEM ↔ SETTINGS ↔ ABOUT) use the SX
and/or DX keys (see figure below), then press the ENT key to access them.
BASIC
←
OK
→
Within each menu item there is a list of parameters that can be scrolled using the SX and/or DX keys. Once you have
identified the parameter you want to edit, press the ENT key.
The value of the selected parameter starts flashing, meaning that you have entered the parameter edit mode. Now move
with the SX and/or DX keys to modify the value, then press ENT to save it.
NOTE: at any time you can press the ESC key to exit the menu or cancel what
you are doing.
KEY
SX
Scroll left
ENT
Enter the menus and save the parameters
DX
Scroll right
ESC
Exit the menus and cancel the current operation
ADVANCED
←
OK
→
FUNCTION
SYSTEM
SETTINGS
←
OK
→
←
8
ABOUT
OK
→
←
OK
→
