Tester Overview - SPX LeakTamer Plus Evap Manual Del Operador

Component Descriptions
1. Power Indicator Lamp turns On when connecting
the power leads to a battery, indicating a good
contact.
2. Smoke Indicator Lamp turns On after pressing
the remote button, indicating the tester is producing
smoke.
3. Supply Hose is used when confirming the integrity
of an EVAP system, when verifying any system for
leaks, or when introducing smoke into a system being
tested for leaks.
4. Exhaust Cone tapers in size from 1" to 3-1/2" with
a 5/16" opening at the small end of the cone to which
a short section of hose is connected. The supply nozzle
is inserted into the end of the attached hose to introduce
smoke into any system with an opening that fits these
dimensions. The exhaust cone may also be used as an
exhaust plug when testing intake vacuum systems.
5. EVAP Service Port Adapter (standard size)
connects directly to the factory service access port on
the vehicle when connecting to a vehicle's fuel vapor
recovery system.
6. Schrader Valve Removal / Installation Tool is
designed to work on many different kinds of vehicles.
7. Cap Plug Kit is used to seal the intake ducting of
the engine being tested. The plugs range in size from
1-3/4" to 4-1/2", and may be used to seal either the
inside diameter of an opening, or flip them over and
seal the opening at the outside diameter.
8. Spotlight helps locate smoke when searching for
leaks.
9. Remote Starter & Power Cables are used to
operate the tester. The tester stays ON for five (5)
minutes after the remote button is pressed; press the
button again to turn the tester OFF.
10. Flow Meter with pointer-flag establishes a quick
PASS / FAIL when determining if the vehicle being
tested has a leak.

Tester Overview

10
9
8
7
Features Included But Not Shown Here
Drain / Fill Area (located on the top-back of the tester):
Much like a motor oil dipstick, there are low and high
marks engraved on the tester's dipstick. Remove the
dipstick to maintain the smoke solution level at the FULL
mark, and to drain and replace the smoke solution during
yearly maintenance service.
Smoke-Producing Solution: LeakTamer Plus is
shipped with a full charge of smoke-producing solution
– enough to perform approximately 500 tests before
needing a refill. We recommend replacing the solution
once a year (at the minimum) to help keep the LeakTamer
Plus operating in a like-new condition for many years to
come.
Water Separator / Filter (on back of tester) ensures a
clean supply of nitrogen or air.
1
2
3
4
5
6
5