Storage; Warranty Certificate - Active A-T143 Manual De Instrucciones

GB
ENGLISH
DRILL
Always make sure of the condition of the drill, if worn,sharpen
or replace the knife and the drill center.
This must be checked regularly.
Follow all the maintenance instructions previously described.
- Clean the machine completely and lubricate the metallic
parts.
- Empty fuel tank and run engine until dry. Store the auger in a
dry place.
This machine has been designed and produced with the most advanced technology. The manufacturer guarantees
its products for 24 months from the date of purchase, with the exception of product for continuous professional
service, used for third parties which are guaranteed for 12 months from the date of purchase.
LIMITED WARRANTY
1 ) Warranty starts on the date of purchase, the manufacturer will supply free of charge any part defective in
materials and workmanship. Warranty does not provide for the replacement of the machine.
2) Product failures will be scheduled and repaired according to the normal work flow; any possible delay cannot
lead to damages nor to an extension of the warranty period.
3) Claims under warranty will be accepted on submission to your Authorized Service Dealer of the completed and
duly stamped. Warranty Certificate together with the original purchase document stating the date of purchase.
4) Warranty fails in the case of:
- evident lack of maintenance;
- incorrect use of the machine or tampering;
- use of incorrect fuel and or lubricants;
- use of non-genuine parts;
- repairs made by unauthorized service people.
5) Parts subject to wear and tear such as cutting items, clutch or cutting safety devices filters, clutch etc., are not
covered by guarantee.
6) Shipping / transportation charges and labour incurred in replacing defective parts on warranty, shall be born
by the purchaser.
7) Claims for damages incurred during transportation have to be immediately reported to the carrier: failure to do
so will invalidate the warranty.
8) Should any failure occur during or after the warranty period, customer has not the right to interrupt payment nor
to a price discount.
9)The manufactorer is not responsible for any direct or indirect damage caused to persons or things by failures
of the machine or by a forced suspension in its use.
MODEL
S.N. n.°
DATE:
...........................

9. STORAGE

10. WARRANTY CERTIFICATE

T 143 T 152
DEALER:
PURCHASER:
WARNING: the penetration and the speed of drilling depends
of the efficiency of the knife and centre drill.
- Remove the spark plug, put a small amount of oil into the
cylinder rotate the crankshaft several times using the starter
in order to distribute the oil,put the spark plug back in.
ATTENTION: all maintenance operations not reported in this
manual must be carried out by an authorized ACTIVE service
dealer.
T 160
32
TDU 155