Idiomas disponibles
Idiomas disponibles
NOTE:It is normal for smoke to be emitted from a new engine during and after
first use.
WARNING!
Always shut off engine before fuelling.Never add fuel to a machine with a running
Or hot engine.Move at least 9m from refueling site before starting engine.
Do not smoke!
STARTING AND STOPPING
WARNING!
Never start or run the engine inside a closed or pooely ventilated area;
breathing exhaust fumes can kill.
WARNING!
Do not have the auger bit attached when starting a cold engine .The auger bit
may rotate when the engine starts with the throttle lock engaged.Start the engine
following
The procedure below.Allow the engine to warm up.with the engine warm,you may
stop
The engine,fit the auger bit and re-start the engine following the warm start
procedure.
NOTE:Be sure to return the stop switch to the "I"position before trying to start
unit.
TO START A COLD ENGINE
◼ Place the engine switch to he on "I"position.
◼ PRIME-press the primer bulb 10 times slowly.
◼ SET the choke lever to the "START" position.
◼ Lock on the throttle by pulling the throttle trigger and pressing in the lock button..
◼ PULL the starter rope with a quick firm and consistent upwards motion until the
engine fires or starts and runs.
◼ If the engine fires（pops）but does not continue to run, move the choke lever back
to the "RUN" position.
◼ Allow the engine to warm up for 5-20 seconds.
