Idiomas disponibles
Idiomas disponibles
OPERATION
WARNING:
Battery tools are always in operating condition.
Lock the switch when not in use or carrying at your
side, when installing or removing the battery pack,
and when installing or removing accessory heads.
Avoid running the tool at low speeds for extended periods
of time. Running at low speeds under constant usage may
cause the tool to become overheated. If this occurs, cool the
tool by running it without a load and at full speed.
INSTALLING/REMOVING BATTERY PACK
See Figure 2, page 8.
To install, lock the switch trigger and insert the battery
pack.
Make sure the latches on each side of the battery pack
snap in place and that battery pack is secured in the
product before beginning operation.
To remove, depress the latches.
MAINTENANCE
WARNING:
When servicing use only identical replacement
parts. Use of any other parts can create a hazard
or cause product damage.
WARNING:
Do not at any time let brake fluids, gasoline,
petroleum-based products, penetrating oils, etc.,
come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which can
result in serious personal injury.
NOTE: ILLUSTRATIONS START ON PAGE 8
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
This product has a 90-Day Satisfaction Guarantee Policy, as well as a
For Warranty and Policy details, please go to www.RIDGID.com
INSTALLING/REMOVING ACCESSORY
HEADS
See Figures 3 - 4, page 8.
Lock the switch trigger and remove the battery pack.
Depress the latches on both sides of the power base with
Place the desired accessory head on the power base and
NOTE: The head can be installed at 90° angles to best
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
REPLACING THE DRIVE GEAR COVER
See Figure 5, page 8.
If over time you notice the noise of the tool getting louder
than usual, check the condition of the drive gear cover. If the
cap is excessively damaged so that the metal gear is clearly
visible, remove it and replace with the spare cap included.
NOTE: To reduce the noise level of the tool, do not operate
without the drive gear cover installed.
Three-year Limited Warranty.
or call (toll free) 1-866-539-1710.
6 - English
one hand while pulling the head away from the tool with
your other hand.
push until the latches click into position. Pull on the head
to make sure it is securely installed before operation.
suit your application needs.
