JANE CONCORD iGRADE Manual De Instrucciones página 35

• There is a storage compartment for the buckle in the base of the seat. Open it and put
the fully fastened buckle inside. (5e)
• The buckle tabs can be hidden inside some bags that you will find in the upholstery (5f)
• Close the compartment and put the backrest skirt back in place.
_ Installing the booster seat with backrest without the ISOFIX anchors
If you decide to install the iGRADE booster seat with backrest without the ISOFIX anchors, simply
place the booster seat on the vehicle seat and pass the seat belt through the bet guides on the
sides of the seat (12) and the one on the side of the headrest (13). These guides are marked
green.
WARNING: When the booster seat with backrest is not in use, it still needs to be fastened with the
vehicle 3-point seat belt. In the event of sudden braking or an accident, an unrestrained booster
seat can get flung about and cause injury to other passengers.
_ Installing the booster seat with backrest with the ISOFIX anchors
The booster seat with backrest can be fastened with the ISOFIX anchors, which gives the seat
more lateral stability.
To install the booster seat follow the steps below:
• Pull the two ISOFIX anchors (5) out fully by pressing the buttons on each anchor (5a) and
sliding then out. (6a)
EN
33