JANE CONCORD iGRADE Manual De Instrucciones página 34

_ Removing the seat when installed using ISOFIX:
• Release the ISOFIX anchors by pressing both ISOFIX buttons (5a). The signals on the
ISOFIX buttons (5b) will turn red.
• Remove the seat. Press the ISOFIX anchors (5) to store them inside the base.
_ 2 Use for children from 100 to 150 cm using the car seat belt
_Changing the safety seat into a booster seat with backrest
To switch the iGRADE safety seat into a booster seat with backrest, the seat must be in the
forward facing position. To complete the following steps the seat must be uninstalled from
the car.
• Rotate the leg by about 45 degrees. (5a)
• Press the leg support towards the base until it is fully inserted. (5b)
• Adjust the length of the leg to the shortest position by releasing the leg lock using the
buttons (4b).
• Rotate the leg towards the base until it fits into the slot. There is a lock that prevents it
from coming out. (5c)
• Fully loosen the belts by pressing the lock. (7b) (5d)
• Remove the fabric protector cover from the buckle. Lift up the backrest skirt and remove
the buckle from its slot. Refasten the belts to the buckle.
EN
32