Idiomas disponibles
Idiomas disponibles
Hydraulic connection
Connect the inlet pipe A to the pump inlet and the water outlet B to the tank outlet as shown in the diagram
opposite.
A
B
Does your hose have a threaded connection?
Ҭ
If yes, screw the hose directly onto the pump.
×
If not:
Choose the connections and clamp appropriate for your water inlet hose (skimmer): Ø32 mm or Ø38 mm.
1
– if Ø38 mm, the clamps and keys are already assembled
– if Ø32 mm, remove the spanners from the Ø38 mm clamps and screw them onto the Ø32 mm
clamps.
Assemble the fittings you need and use a clamp to secure each connection
2
Position the hose on the connector.
3
Fit and tighten the clamp supplied.
4
⚠
Electrical connection
Please refer to the section «Start-up», page 30, before switching on the filtermax
filter unit! Filtermax must never be operated without water.
The electrical connection of the FilterMax filter unit includes a 10mA differential cir-
cuit breaker. Test it regularly to ensure it is working properly.Before plugging in your
FilterMax, make sure that the electrical socket is well protected, earthed and protec-
ted from rain and splashing water.
Electrical connection equipment supplied: 5 meter power cord.
During operation, some parts of the pump are under electrical voltage. Any operation on the pump or connected
equipment must be carried out after switching off the power or disconnecting the starting devices.
If the power cord is damaged, it must be replaced by a qualified electrician and must
comply with local regulations to avoid any hazards from occurring.
10mA earth leakage circuit breaker: Press RESET to switch it on. The power
LED lights up red: the heat pump is switched on.
I
NSTALLATION
B
→
A
B
A
+
B
A
→
Power indicator
Reset
ON
Test
OFF
EN | 27
EN | 27
