Idiomas disponibles
Idiomas disponibles
Preparing the tank
Place first O-ring on the pump inlet.
1
Place second O-ring on the pump outlet.
2
Gently clip the pump onto its base.
3
Place the third O-ring over the inlet at the top of the tank.
4
Place the tank next to the pump on the base, in the place provided for this purpose.
5
Locate the UP and DOWN markings on the elbow fitting
6
The mark UP on the upper part of the elbow indicates the clamp to be fixed to the tank.
The DOWN marking on the bottom of the elbow indicates the clamp to be attached to the pump.
Screw on the pump/tank connection elbow. Tighten as much as possible by hand without using tools.
7
Place the fourth sealing gasket on the outlet at the bottom of the tank.
8
4
5
Preparing the basket
Place the bag of balls supplied in the filter basket.
1
Notes:
The bag makes maintenance easier.
•
The balls can also be placed in the basket without the bag.
•
For older models with several bags, do not leave any space between
•
the 2 bags, to ensure maximum filtration.
a. Place the grid in the basket.
2
b. Engage the 3 attachment points of the grid in the 3 notches of the basket.
c. Turn the grid slightly to the left to secure it completely
TIP : slide your fingers under the hooks to turn the grid
The basket should not be picked up by the handle of the grid, but by the handle!
NOTE: The grid keeps the filter balls in the correct position. Without the grid, the balls
will float and spread out, reducing the quality of filtration. For this reason, it is also impor-
tant to have a sufficient quantity of filter media in the basket: 250g (dry weight).
Insert the basket (once closed and with the filter balls) into the tank.
3
Make sure that the basket is well positioned at the bottom of the tank.
24 | EN
24 | EN
A
SSEMBLY
The pump is heavy.
6
UP
DOWN
5
2
3
8
250g
OK
NO
NO
OK
1
