Idiomas disponibles
Idiomas disponibles
INSTALLATION
1
Remove the 2 screws from the plate on the right side of the
hood to gain access to the junction box.
2
Remove the screw holding the junction box.
3
Remove the pre-cutting inside the junction box. Temporarily
close the hood cover.
4
Determine according to the air outlet, the transition to install.
Place the hood upside down to install the transition with two 3.5 x
9.5 mm screws.
6" transition
5
A minimum of 3 people is required. Lift the hood to the ceiling
for installation. NOTE: Exhaust duct and duct connections must be
installed before placing on the ceiling.
6
Place the duct of your domestic installation for the hood air
outlet in the previously installed transition.
7
Pass the connection conduit from your domestic installation
through the pre-cut that was previously removed from the hood
junction box.
8
Once the ductwork is installed lift the hood to attach it to the
ceiling, push until the retaining clips click above the ceiling..
9
To secure the hood, you will need to turn the 4 set screws
clockwise with a 3/16" allen wrench.
10 General electrical supply VAC of the hood:
•
Connect black wires together (L)
8" transition
•
Connect the white wires together (N)
•
Connect green-yellow / yellow wires together (
11 Once the electrical connection has been made, replace the
junction box cover, and reinstall the plate covering the junction box.
9
Clic!
Clic!
B
A
D
C
N
L
N
N
)
L
L
