SAFETY RULES AND RECOMMENDATIONS FOR THE INSTALLER
Read this guide before installing and using the
appliance.
During the installation of the indoor and outd-
oor units the access to the working area should
be forbidden to children.
Unforeseeable accidents could happen.
Make sure that the base of the outdoor unit is
firmly fixed.
Check that air cannot enter the refrigerant sys-
tem and check for refrigerant leaks when mo-
ving the air conditioner.
Carry out a test cycle after installing the
air conditioner and record the operating data.
The ratings of the fuse installed in the built-in
control unit are T 5A / 250V .
The user must protect the indoor unit with a
fuse of suitable capacity for the maximum in-
put current or with another overload protection
device.
Ensure that the mains voltage corresponds to
that stamped on the rating plate. Keep the sw-
itch or power plug clean. Insert the power plug
correctly and firmly into the socket, thereby a-
voiding the risk of electric shock or fire due to
insufficient contact.
Check that the socket is suitable for the plug,
otherwise have the socket changed.
The appliance must be fitted with means for
disconnection from the supply mains having
a contact separation in all poles that provide
full disconnection under overvoltage
category III conditions, and these means
must be incorporated in the fixed wiring in
accordance with the wiring rules.
Do not install the appliance at a distance of
less than 50 cm from inflammable substances
(alcohol, etc.) Or from pressurised containers
(e.g. spray cans).
If the appliance is used in areas without the
possibility of ventilation, precautions must be
taken to prevent any leaks of refrigerant gas
from remaining in the environment and creat-
ing a danger of fire.
The packaging materials are recyclable and
should be disposed of in the separate waste
bins.Take the
of its useful life to a special waste collection
inverter
centre for disposal.
Only use the
instructed in this booklet. These instructions
are not intended to cover every possible
condition and situation. As with any electrical
household appliance, common sense and
caution are therefore always recommended
for installation, operation and maintenance.
The appliance must be installed in accordance
with applicable national regulations.
Before accessing the terminals, all the power
circuits must be disconnected from the power
supply.
The appliance shall be installed in accord-
ance with national wiring regulations.
The
inverter
installed by professional or qualified
persons.
1
inverter
air conditioner at the end
inverter
air conditioner as
air conditioner must be