EGO PRO X PGX1600E-H Manual página 10

CHARGING A HOT OR COLD BATTERY PACK
EN
If the battery pack in the charging dock is outside
of the normal temperature range, the corresponding
battery-bay status indicator will glow solid red and the
power indicator on the battery pack will turn off. When
the battery pack cools down or warms up to a normal
temperature range, the battery pack will resume to
charge automatically.
A BATTERY PACK OR DOCK/POWER BANK ERROR
If the battery pack error is detected, the corresponding
battery-bay status indicator will flash red and the power
indicator on the battery pack will turn off.
1. Remove and re-insert the battery pack in the dock/
power bank. If the battery-bay status indicator still
flashes red, try charging a different battery pack that
is known to be functional.
2. If the new replacement battery pack can be charged
normally, the original battery pack is faulty.
3. If the battery-bay status indicator still flashes red
after trying to charge a functional battery pack, reset
the hub by unplugging the hub from power supply
and waiting until the hub status indicator goes out.
Then reconnect the plug to the power supply.
4. If the battery-bay status indicator still flashes red
after step 3, the dock/power bank may be faulty.
MOUNTING THE HUB
Wall-mount Holes
1. Make sure the two rubber blocks fit into the upper
slots of back of the hub (Fig. E1).
2. Use four M5, at least 76 mm length screws and
washers (not included) to securely mount the hub to
the wall (Fig. E2).
NOTE:
Mounting surface should be at least 19 mm
thickness to maximize holding the hub.
Mounting onto E-track Rail (kit sold separately)
(Fig. F)
F-1 E-track Clip (2)
F-2 E-track Rail
F-3 Rubber Bumper (2)
F-4 Bolt and washer set (2)
EGO E-track mounting kit is required to mount the hub
onto an E-Track rail.
1. Disconnect the hub from power outlet.
2. Remove the two rubber blocks shown in Fig. E1.
10
56 VOLT PGX
3.
4.
5.
6.
7.
NOTE:
anti-theft device using a padlock (not included). The
shackle diameter range is 5-7 mm.
COMMUNICATION TECHNOLOGY
For information on our full range of connected products
and services, including connection instructions, please
scan QR Code below or visit
www.egopowerplus.eu/connect.
1600W HUB — PGX1600E-H
TM
Install the E-track clips (included in the kit) into the
recessed areas (vacated by the rubber blocks) as
shown in Fig. F.
Secure each E-track clip to the hub using M5 bolt
and washer sets by assembling tool (included in
the kit).
Insert two rubber bumpers (included in the kit) into
the outer lower slots on back of the hub.
Snap the hub to the E-track rail using the E-track
clips as shown and make sure the hub is secured
to the rail.
To remove the hub from the E-track rail press the
release levers on the E-track clips and pull the hub
away.
The hole in the E-track clip can function as an