Hoover Lavatrice HW 410AMC/1-S Manual Del Usuario página 73

The programme selector must be
returned to the OFF position at the end
of each cycle or when starting a
subsequent wash cycle prior to the next
programme being selected and started.
PAUSING THE MACHINE
l
Keep the START/PAUSE button pressed
for about 2 seconds (some light indicators
and the residual time display will flash,
showing that the machine is paused).
For safety reasons, in some wash
cycle phases, the door can be opened
only if the level of the water is below
its lower edge and if the temperature
is less than 45°C. If these conditions
are met, wait for the DOOR LOCKED
light to switch off before opening the
door.
l
Press the START/PAUSE button again to
re-start the programme from the point it
had been paused at.
CANCELLING THE SET PROGRAMME
l
To cancel the programme, set the
selector to the OFF position.
l
Wait until the DOOR LOCKED light has
gone out before opening the door.
TEMPERATURE SELECTION
button
l
This button allows you to change the
temperature of the wash cycles.
l
It is not possible to raise the temperature
over the maximum allowed for the
programme, in order to protect the
fabrics.
l
If you want carry out a cold wash all the
indicators must be off.
SPIN SPEED button
l
By pressing this button, it is possible to
reduce the maximum speed, and if you
wish, the spin cycle can be cancelled.
l
If the label does not indicate specific
information, it is possible to use the
maximum spin expected in the program.
To prevent damage to the fabrics, it is
not possible to increase the speed
over the maximum allowed for the
programme.
l
To reactivate the spin cycle press the
button until you reach the spin speed you
would like to set.
l
It is possible to modify the spin speed
without pausing the machine.
An over dosing of detergent can
cause excessive
appliance detects the presence of
excessive foam, it may exclude the
spinning phase or extend the duration
of the program and increase water
consumption.
The machine is fitted with a special
electronic device, which prevents the
spin cycle should
unbalanced. This reduces the noise
and vibration in the machine and so
prolongs the life of your machine.
DELAY START button
l
This button allows you to pre-programme
the wash cycle to delay the start of the
cycle for up to 24 hours.
l
To delay the start use the following
procedure:
- Select the required programme.
73
foaming. If the
the load be