Idiomas disponibles
Idiomas disponibles
Turn the air regulator "C" until the flame steadies.
To convert to TOWN GAS, the adjustment of the pilot flame will be carried out turning the adjusting screw "B" until the
flame is stable.
Table taps minimum flow adjustment
IMPORTANT: before adjustment, the burner must have fully operating for at least 15 minutes.
a)
For NATURAL GAS and TOWN GAS, turn adjustment screw "F" one way or the other until the flame is
established in the minimum position. For L.P.G. it will be fully tightened (Fig. 5).
Turning the burners on.
a)
Open the main general gas-tap installed on the outside of the appliance. It is necessary to remove the
shield in the CG9-11 and CG9-10 models.
b)
Lightly press the control corresponding to the burner you want to ignite until it becomes unlocked and
turn it anticlockwise to the PILOT position (Fig. 6, no. 2), press this position again and light the pilot with
a flame until it is stable.
c)
Then onwards, to ignite the burner, turn the control anticlockwise to the MAXIMUM position (Fig. 6, no.
3). MINIMUM position (Fig. 6, no. 4).
Loosen the control when this position is reached.
IMPORTANT: To go to the MAXIMUM position or any other one, you must always press the control.
Switching the table burners off.
a)
If it is in any of the MAXIMUM, MINIMUM or intermediate positions, the control must be pressed and
turned clockwise to the PILOT position (Fig. 6, no. 2) and then stop pressing it.
In this position, the burner will switch off, and the pilot will remain on.
b)
To turn the pilot off, press the control and turn it to the OFF position (Fig. 6, no. 1).
Turning the gas oven on.
a)
Remove the protective plastic.
b)
Using the plate lifting lever will clear the first oven plate in the OP oven. In the rest of the ovens, move
the pilot light ignition access cover.
c)
Press the "P1" push button (Fig. 8), and at the same time press the pilot piezoelectric "P3" (Fig. 8)
repeatedly, until the pilot flame lights up. Keep "P1" fully pressed down until the pilot flame is stable when
it is released.
d)
Then onwards, to light the burner, turn the thermostat control "P2" (Fig. 8) anticlockwise, to the position
corresponding to the chosen temperature (refer to table no. 10).
e)
To assist turning on the oven, a plate lifting plate is included with each cooker to check the proper
functioning of the oven. Their method of use can be observed in the following figure.
Switching the gas oven off.
a)
Turn the thermostat control (Fig. 8) clockwise to the pilot position "PO". In this position, the burner will
switch off, and the pilot will remain on.
b)
To switch the pilot off, press push button "P2" fully in (Fig. 8).
2.-USE
37
