Warranty Term - TRAPP HT-500 Manual De Instrucciones

Metalúrgica Trapp Ltda.
Guarantees this product for 6
months, warranty effected from
date of purchase stated on
consumer invoice.
This product has full coverage
against manufacturing defects,
defective parts, and service cost.
For servicing, customer must take
product to nearest authorized
TRAPP service dealer and
present proof of purchase
Warranty will be voided if
product: is damage due to
accident, was improperly used,
presents lack of maintenance (not
following instruction stated on
TRAPP Instruction Manual),
presents signs of violation, or has
been serviced by unauthorized
dealer.
Warranty will also be voided if
product is exposed to humidity,
bad weather, corrosive sea air
etc.
Warranty will not cover parts
which present natural wear.
Note:
All parts proven to be defective
will be replaced by
manufacturer at no cost, under
no circumstances will
machine/equipment be replaced
and/or exchanged.
24

Warranty Term

Consumer is responsible for
handling & shipping of product
to the nearest TRAPP authorized
service dealer.
This warranty is limited and is
non-transferable, only valid upon
presentation of purchase invoice.
This product is subject to
modifications in design and
technical specifications without
prior notice from manufacturer.
Motor warranty covers the
following manufacturing
defects:
Spiral short circuit, short circuit
between phases, rotor failure,
and assembly error.
Warranty does not cover defects
caused by improper use,
overload, lack of phase,
improper or incompatible
tension, bearings, bent or broken
axle, or other causes due to
negligent, careless transport and
storage.
Note:
Always use original TRAPP spare
parts and consult TRAPP
authorized service dealers.