Adjusting The Microphone; Removing The B902 System From The Helmet - Nolan N-Com R Serie Manual De Instrucciones

EN
•
Position the left and right speakers in the respective housing obtained in the polystyrene cheek
padding. If necessary, rotate the speakers slightly in their housing. If necessary, secure them using
the adhesive strips supplied as standard equipment.
•
Reassemble the cheek padding.
3.2.

Adjusting the microphone

The B902 system makes it possible to adjust the position of the microphone in order to facilitate its
positioning in the different helmet models. Proceed as follows:
•
Open the clip positioned on the microphone boom, operating as indicated in Fig. 21.
•
Adjust the microphone (Fig. 22).
•
Close the clip (Fig. 23).
Fig. 21
To ensure good voice transmission quality, it is recommended to position the microphone sponge at
the side of your mouth.
3.3.

Removing the B902 system from the helmet

Fig. 24
FOR N87, N80-8 and N100-5 HELMENTS ONLY – removing the keypad
•
Remove the keypad from the shell, as indicated in Fig. 25.
•
Rotate the keypad in a counterclockwise direction (Fig. 26).
•
Remove the cheek padding and the shell gasket.
Fig. 25
12
Fig. 22
•
•
Fig. 23
Remove the cheek padding and the shell
gasket.
Remove the keypad from the shell, as shown
in Fig. 24.
Fig. 26