Tabla de contenido
Idiomas disponibles
Idiomas disponibles
NOLAN nCOM intercom 0025
23-05-2006
16:22
Pagina 25
ENGLISH
4.2. Switching off the system
- Press the "on" key and keep it pressed for about 4 seconds until you hear a low buzz and the LEDs turn off.
4.3. Adjusting the volume
- Turn on the system.
L L
M M
Briefly press key "
" or "
" to adjust the volume.
L L
M M
The volume can be adjusted to 7 different levels, from the lowest to the highest. Each time key "
" or "
" is pressed
(confirmed by a buzz in the earphone) the volume is increased or decreased by one level up to the highest value or down to
the lowest one, marked by a high buzz and a low buzz respectively.
Warning:
Cell phones (and/or other devices that can be connected to N-Com) are equipped with their own volume
adjustment. Adjust the volume levels of the connected device and of the N-Com system so as to obtain the desired volume
prior to using the system while riding.
Caution:
Listening at a very high volume may distract you from riding your vehicle and create dangerous situations or limit
the ability to hear background noises.
4.4. Switching the intercom mode on and off
Switching it off
- Briefly press the "on" key. Now both microphone and passenger's loudspeakers are disconnected from the system.
Switching it back on
L L
- Press the "
" key for approximately 2 seconds (double buzz in the earphone).
Note: In case of any malfunction, the system can be reset. Simply remove the e-box from the helmet and then put it back
in place.
5. USING THE SYSTEM WITH A CELL PHONE
Connect the pilot's helmet to a cell phone using the Mobile Wire specific for your phone (sold separately).
Note: Due to the varying strength of the network signal, there may be interferences in the wire connections which do not
depend on the N-Com system or the cable used.
Note: Operation of the Intercom Kit system with a cell phone depends on the model of cell phone used and the software
version installed on it.
25
Capítulos
Tabla de contenido
