Idiomas disponibles
Idiomas disponibles
Before installing, check that all parts are complete and the product is intact.
If you want to use the heater independently, attach the supplied feet following these instruc-
tions. The heater must be mounted on a clean, stable and level surface.
LEG INSTALL ATI O N
1. Place the product face down on a soft cotton cloth
or rug.
2. Attach legs to heater base using screws provided.
Align the holes in the base with the holes in the
legs, insert the screws into the holes and tighten
with a screwdriver (not included).
WA L L I N STALL ATI ON
Note: Before drilling holes in the wall, make sure there are no cables or other pipes in the
wall to avoid damage. Remember that the screws on the wall must be fixed and firm to en-
sure the safe installation of the heater. Please note the safety distance mentioned below.
1. During installation, the heater must be kept at a safe enough distance from combustible
materials and gas and away from water.
2. Always keep the minimum installation distances of the heater from both the floor and the
ceiling. NEVER place the heater at a distance less than 15 cm from the floor or less than
50 cm from the ceiling.
Hook type bracket.
1. Take four brackets, six expansion bolts and six screws out of the box, and attach two
brackets to the wall with the distances between the bracket holes as shown in the illus-
tration below.
ALL THE MODELS
Holes for support
8
16
8
50
UNIT:mm
2. Attach two brackets to the bottom of the product as shown in the illustration.
8
E NGL I SH
INSTALLATION INSTRUCTIONS
2000W MODEL
Support separation
450mm
2500W MODEL
Support separation
530 mm
