Idiomas disponibles
Idiomas disponibles
Telescopic rails
Clean the accessories thoroughly with
warm water, detergent and a soft clean
cloth on first use.
Fastener
•
On each telescopic rail there are
fasteners that allow you to remove them
for cleaning and repositioning.
•
Remove the side runner. See section
"Removal of the wire shelf".
•
Hang the telescopic rail top fasteners
on the side rack level reference wire
and simultaneously press the bottom
fasteners until you clearly hear the
fasteners clip into the side rack level
fixing wire.
•
In order to remove, hold the front
surface of the rail and repeat the
previous instructions in reverse.
5. CLEANING AND
MAINTENANCE
5.1 CleaninG
WARNING: Switch off the appliance
and allow it to cool before cleaning is
Fastening tab
EN - 24
to be carried out.
General Instructions
•
Check whether the cleaning materials
are appropriate and recommended by
the manufacturer before use on your
appliance.
•
Use cream cleaners or liquid cleaners
which do not contain particles. Do not
use caustic (corrosive) creams, abrasive
cleaning powders, rough wire wool or
hard tools as they may damage the
cooker surfaces.
Do not use cleaners that contain
particles, as they may scratch the
glass, enamelled and/or painted parts
of your appliance.
•
Should any liquids overflow, clean them
immediately to avoid parts becoming
damaged.
Do not use steam cleaners for
cleaning any part of the appliance.
Cleaning the Inside of the Oven
•
The inside of enamelled ovens are best
cleaned while the oven is warm.
•
Wipe the oven with a soft cloth soaked
in soapy water after each use. Then,
wipe the oven over again with a wet
cloth and dry it.
•
You may need to use a liquid cleaning
material occasionally to completely
clean the oven.
Cleaning the Gas Hob
•
Clean the gas hob on a regular basis.
•
Take off the pan supports, caps and
crowns of the hob burners.
•
Wipe the hob surface with a soft cloth
soaked in soapy water. Then, wipe the
hob surface over again with a wet cloth
and dry it.
•
Wash and rinse the hob-burner caps.
Do not leave them wet. Dry them
