Technical Specifications - Teka HLC 844 Instalación Y Mantenimiento

• Deactivate the door lock following the in-
structions in the User's guide supplied with
this manual.
• To continue cooking, re-select the desired
cooking function.
I have turned the control dial to position
and selected a pyrolysis programme
(P1, P2 or P3) but the
quickly and a buzzer sounds
• The oven door is not closed properly, so
the door cannot be locked and the pyrolyt-
ic process has been blocked.
• Check the door and make sure it is prop-
erly closed. Then set the control dial to the
required position and repeat the sequence
to activate the pyrolysis.
I have turned the control dial to position
and selected a pyrolysis programme
(P1, P2 or P3) but the symbol
not light up and the oven does not heat
up
• The door switch is not working even
though the door is properly closed.
• Call the Technical Assistance Service De-
partment as there is a fault in the door
switch.

Technical specifications

WARNING
If these problems persist despite these tips,
contact the Technical Service Department.
40
Installation & Maintenance
symbol flashes
does
The pyrolysis programme has ended and
the oven is cold, but the door is locked
and symbol and 0:00 are flashing
• You did not turn the control dial to position
when the pyrolysis programme ended.
• Set the control dial to position
The control dial is in position
door is still locked
• The oven has not cooled down to the safe
temperature limit.
• Wait until the oven cools and the symbol
goes off.
Inform the Technical Service Department of the
kind of problem you are experiencing and give
the:
1. Serial Number (S-No)
2. Model of Appliance (Mod.)
This information is on the oven identification
plate which is on one side of the opened door.
.
and the