Kramp MM4510 Instrucciones De Uso página 2

OPERATION INSTRUCTIONS FOR KRAMP DIGITAL MOISTURE METER
Thank you for choosing the Kramp Digital grinding grain moisture meter! Please read the whole manual before using the
meter.
NOTE: Your moisture meter can be used to determine moisture of tens of different grains, seeds and pulses. For simplicity,
this manual refers to all crops as "grains".
1. PACKAGE CONTENT
- Kramp Digital grain moisture meter
- Grinding cap
- Carrying case
- Cleaning brush
- Operation instructions
- 9 V battery
2. PREPARATION
Insert battery (observe polarity!). Press the ON/OFF button to switch on. Use the < and > buttons to navigate the list of
grains and settings.
To adjust a setting, press Test and then adjust using the < and > buttons. Finally confirm the change by pressing the Test
button.
THE FOLLOWING ADJUSTABLE SETTINGS ARE AVAILABLE:
- Language: language of the user interface
- Contrast: display contrast (darkness)
THE FOLLOWING INFORMATION CAN BE FOUND WITHIN THE LIST OF SETTINGS:
- Battery voltage: replace battery if indication is less than 7 V
- Temperature: temperature of the grinder
- Version: software version
Remove battery before long term storage. Do not attempt to charge the battery or expose it to excessive tempera
ture. Do not touch electrolyte leaking from a damaged battery.
3. SAMPLES
- Always take several samples across a lot of grain and use average as the result
- Remove impurities and green or abnormal kernels
- When measuring direct from a dryer, give the sample time to cool a little before measuring
4. MEASURING
1. Press ON/OFF to switch on.
2. Choose a grain using the < or > buttons.
3. Display will indicate the correct sample size (9 ml or 11 ml). Fill the appropriate sample cup on the
grinding cap with grain.
4. Pour the sample into the grinder evenly.
5. Put the grinder cap on its thread and twist clockwise to grind.
6. Twist the cap until the stop pin on the cap hits the rim of the grinder.
7. Press Test and wait for the result.
8. Moisture content is on the left side of the display and average on the right side.
9. If the display shows > or < in front of the result, the moisture is outside the measuring range. For example, "<11%"
means the sample is too dry and ">40%" means the sample is too wet to be measured. Measuring range varies with
grain and temperature.
10. Clean the grinder and the cap after each measurement. Use the supplied cleaning brush.
0118_Manual_Moisture meter_A5.indd 2 0118_Manual_Moisture meter_A5.indd 2
www.kramp.com www.kramp.com
2
GB
18/01/2023 13:21 18/01/2023 13:21