Idiomas disponibles
Idiomas disponibles
OBJ_BUCH-1584-003.book Page 16 Friday, August 17, 2012 10:28 AM
16 | English
Press the button to actuate the charge-control indicator. Af-
ter approx. 5 seconds, the charge-control indicator goes out
automatically.
The charge condition can also be checked when the battery is
removed.
LED Indicators
Continuous lighting of 3 green LEDs
Continuous lighting of 2 green LEDs
Continuous lighting of 1 green LED
Flashing of 1 green LED
When no LED lights up after actuating the button , the battery
is defective and must be replaced.
For safety reasons, the charge condition of the battery can
only be checked when the garden product is at a standstill.
During the charging procedure, the three green LEDs light up
one after the other and briefly go out. The battery is fully
charged when the three green LEDs light up continuously. The
three LEDs go out again approx. 5 minutes after the battery
has been fully charged.
Temperature Control Indicator
The red LED signals that the battery or the electronics of the
garden product (with battery inserted) are not within the op-
timum temperature range. When this occurs the garden prod-
uct will not operate or not at full capacity.
Temperature Control of the Battery
The red LED flashes when pushing button or pressing the
On/Off switch (when the battery is inserted): The battery is
not wihin the temperature range for operation of –10 °C to
+60 °C.
The battery switches off at a temperature above 70 °C until
the optimum temperature range is reached again.
Troubleshooting
STOP
Problem
Possible Cause
Tool fails to operate
Possible clogging
Battery not fully charged
Battery not inserted (properly)
Grass too long
Motor protector has activated
Battery too hot/cold
Isolator key not inserted correctly/fully
There is a short delay in the motor starting after
engaging the On/Off switch
F 016 L70 847 | (17.8.12)
Temperature Control of the Garden Product
Electronics
The red LED lights up continuously when pressing the On/Off
switch: The temperature of the garden product electronics is
below 5 °C or above 75 °C.
Battery Capacity
At a temperature above 90 °C, the electronics of the garden
product switch off until the temperature is within the allowa-
≥ 2/3
ble temperature range again.
≥ 1/3
Area of Cut (Battery Duration)
≤ 1/3
Reserve
The area of cut (battery duration) depends on lawn condi-
tions, grass density, mositure content, grass length and
height of cut.
Switching the machine on and off frequently during cutting
will also reduce the area of cut (battery duration).
To improve the area of cut (battery duration) it is recommend-
ed to cut more frequently, raise the cutting height and walk at
a normal pace.
The example below shows impact of conditions against run
time, for one battery.
Cutting Conditions
Very light, dry grass
6cm
4cm
up to 150 m
up to 300 m
To increase the run time an additional battery or higher capac-
ity battery (Ah) can be purchased from an authorised custom-
er service agent for Bosch garden products.
Light, dry grass
8cm
4cm
Area of cut (Rotak 32 LI)
2
2
up to 100 m
Area of cut (Rotak 32 LI High Power)
2
2
up to 150 m
Corrective Action
Remove the isolator key:
Check underneath the garden product and clear
out as necessary (always wear gardening gloves)
Battery Charging
Inserting the battery
Increase height of cut and tilt garden product to re-
duce starting load
Allow motor to cool and increase height of cut
Allow to cool/warm
Fit correctly
Hold On/Off switch for 1 – 3 s to start motor
Bosch Power Tools
