Ibiza Light MH-BEAM-WASH Manual De Uso página 4

• DISCONNECT DEVICE: Where the MAINS plug or an appliance coupler is used as the disconnect device, the
disconnect device shall remain readily operable.
FEATURES
• 13/18 DMX channels
• Modes: DMX, master-slave, music-controlled, auto, static colour, colour change and gradient
• WASH effect with 3x 6W 4-in-1 RGBW LED
• BEAM effect with 1x 10W RGBW 4-in-1 Cree LED
• Strobe
• Dimmer
• Colour brightness and temperature adjustment
INSTALLATION
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly fixed to
avoid vibration and slipping while operating. Always ensure that the structure to which you are attaching the
unit is secure and able to support a weight of 10 times of the unit's weight. Also always use a safety cable that
can hold 12 times the weight of the unit when installing the fixture.
The equipment must be fixed by professionals at a place where is out of the reach of people and where nobody
can pass by or under it.
FUSE REPLACEMENT
Disconnect the power cord before replacing a fuse and always replace with the same type fuse
• With a flat head screwdriver wedge the fuse holder out of its housing.
• Remove the damaged fuse from its holder and replace with exactly the same type of fuse.
• Insert the fuse holder back in its place and reconnect power.
• The fuse is located inside this compartment. Remove using a flat head screwdriver.
FIXTURE LINKING
You will need a serial data link to run light shows of one or more fixtures using a DMX-512 controller or to run
synchronized shows on two or more fixtures set to a master/slave operating mode. The combined number of
channels required by all fixtures on a serial data link determines the number of fixtures that the data link can
support.
Console Light1
Important: Fixtures on a serial/data link must be daisy chained in one single line.
CABLE CONNECTORS
Cabling must have a male XLR connector on one end and a female XLR connector on the other end.
DMX CONNECTOR CONFIGURATION
Termination reduces signal errors. To avoid signal transmission problems and inter-
ference, it is always advisable to connect a DMX signal terminator.
OPERATING INSTRUCTIONS
NAVIGATION THROUGH THE CONTROL PANEL
Access control panel functions using the four panel buttons located directly under-
neath the LCD Display..
Button Function
MENU Used to access the menu or to return to a previous menu option
UP Scrolls through menu options in ascending order
DOWN Scrolls through menu options in descending order
ENTER Used to select and store the current menu or option within a menu
Switch the unit on. Press the MENU key and following functions will appear in turn. To select a menu item, press
<ENTER>.When a menu function is selected, the display will show immediately the first available option for the
selected menu function.
4
MANUAL - MH-BEAM-WASH
Light2 Light3
Code: 16-2125
8.8.8.8.
MENU UP DOWN ENTER