Idiomas disponibles
Idiomas disponibles
User manual - TXFOT1SWB
Version 1
1. Safety Warnings and Precautions
Product installation must be performed by qualified personnel in accordance with local safety laws and re-
gulations and in compliance with Ministerial Decree 37/08 (Ministerial Decree January 22, 2008 No. 37) and
subsequent updates. The product must be used in full compliance with the operating instructions contained
in this manual.
Installation Warnings
• Use only the power cord provided, installing the product so that the plug is easily accessible.
• The product must not be exposed to dripping or splashing water and should therefore be installed in a dry
environment, inside buildings.
• Moisture and drops of condensation could damage the product. In case of condensation, wait until the pro-
duct is completely dry before using it.
• Do not install the product on or near heat sources or in dusty places or where it may come in contact with
corrosive substances.
• Keep any potential ignition sources away from the installation of the product to avoid and prevent fire of
some parts or components of the product.
• In the case of wall mounting, use expansion anchors appropriate to the characteristics of the mounting
substrate.
• Leave sufficient space around the product to ensure adequate ventilation; excessive temperature and/or
excessive heating may impair the product's operation and life.
• Never look into the product's optical connectors. Laser radiation is not visible to the naked eye and therefo-
re long-term damage cannot be prevented.
• When working with the optical connectors of the partition, always check that the lasers of any optical tran-
smitters connected to it, are turned off.
• In accordance with the European Directive 2014/30/EU, the product must be installed using devices, cables
and accessories to comply with the requirements imposed by this directive for fixed installations.
• CAUTION: To avoid injury, this equipment must be secured to the floor/ the wall according to the installation
instructions
IMPORTANT: Only trained and authorized personnel may service the product. In the event of a fault, do not
attempt to repair it, otherwise the warranty will be void.Never remove the power supply cover, hazardous
voltage parts may be accessible when opening the casing.
CAUTION: Invisible laser radiation. Do not observe directly. CLASS 1M laser product.
13
