cecotec CONGA ROCKSTAR MICRO+ TURBO Manual De Instrucciones página 20

ENGLISH
Using the vacuum cleaner
Make sure the vacuum cleaner's adapter is not connected.
1.
Press the power button to turn the vacuum cleaner on.
2.
3. Use the speed-control knob to set the desired speed.
Attachments
This device includes different accessories that allow cleaning different types of surfaces,
objects, and dirt.
Accessory for upholstery. Fig. 2
This accessory is used for an intense cleaning of upholstered furniture.
1. To install the accessory for upholstery to the main body, align the two parts so that they
fit together until it snaps into place.
To remove, pull the accessory while holding the main body firmly.
2.
Accessory for corners and furniture. Fig. 3
This accessory allows cleaning furniture without damaging it and reaching less accessible dirt
in corners.
To install the accessory for corners and furniture to the main body, align the two parts so
1.
that they fit together until it snaps into place.
2. To remove, pull the accessory while holding the main body firmly.
Motorised brush for upholstery. Fig. 4
1. To install the motorised brush into the main body, align both of them making sure the tab
on the motorised brush matches the guides on the main body, and introduce one into the
other until they are firmly fixed.
To remove, press the motorised brush release button and pull it out of the main body.
2.
Indicator light. Fig. 5
- When the vacuum cleaner is charging, the indicator will light up and keep flashing.
- When the vacuum cleaner is fully charged, the indicator will stop flashing and light up
steady.
- When using the vacuum cleaner, the indicator will stay lit.
- When the vacuum cleaner's battery is low, the indicator will flash.
Charging the vacuum cleaner. Fig. 6
1. Make sure the vacuum cleaner is switched off.
Plug the adapter into a socket and the vacuum cleaner.
2.
An indicator light will light up and keep flashing once the adapter is connected to the
3.
vacuum cleaner.
38
CONGA ROCKSTAR MICRO+ TURBO
- To ensure that the device is always ready for use, we recommend you leave the device
charging when not in use.
- It's normal for the adapter to become warm during charging.
4. CLEANING AND MAINTENANCE
- Turn the appliance off, unplug it from the power socket and allow it to cool down before
cleaning it.
- Use a soft, slightly dampened cloth to clean the surface of the device.
- Never immerse the device in water or other liquids, do not allow liquids to enter the device.
- Do not use abrasive cleaners or scouring pads to clean the product.
- Do not leave the device in a place with direct sunlight.
- Do not leave the device in a wet place after cleaning it.
Filters and tank cleaning. Fig. 7
- To avoid the appliance from overheating and losing suction power, it is suggested to clean
the filters frequently. To make the most of the suction power, it is suggested to clean the
filter after every use.
- The filters shelf life will depend on the accumulated use and the type of particles which
are frequently vacuumed. It is recommended to replace the filters approximately every 6
months.
1. Make sure the vacuum cleaner is switched off and is not connected to a mains socket.
2. Press the dust-tank release button and remove it.
Remove the filter system from inside the tank and separate the filters for cleaning.
3.
Put the filters back in their original position inside the dust tank.
4.
5. Refit the dust tank.
- Vacuum and shake the filters to remove every particle and dust remain that may block
them and difficult the correct air circulation. Remember not to use the vacuum cleaner
without the filters properly assembled.
- Filters cannot be washed inside a washing machine nor dried with a hair dryer.
- Do not brush the high-efficiency filter.
5. TROUBLESHOOTING
Problem Possible cause
The vacuum cleaner The battery is exhausted.
does not work.
ENGLISH
Possible solution
Charge the battery.
39
CONGA ROCKSTAR MICRO+ TURBO