Cleaning And Maintenance - cecotec HYDROBOOST 3200 TOTALCLEAN Manual De Instrucciones

ENGLISH
Final rinse
Start the final rinse from bottom to top. Make sure that the surface is well rinsed, and that all
dirt has been removed.
Turning off
- Make sure there is no detergent in the system.
- Turn off the motor. Turn off the water supply.
- Once the product and the water supply have been turned off, press the trigger to
depressurise the device.
- After each use, wipe the surface of the pressure washer with a clean, damp cloth.
Warning
- Do not turn off the water supply until the motor has been switched off, as this could cause
serious damage to the pump and motor.
- Do not remove the high-pressure hose from the machine while the system is being
pressurised. To depressurise the device, turn off the motor and water supply and press the
trigger 2 or 3 times.
Tips for extending the shelf life of the product
- Do not use the product without water.
- Do not use the product with hot water.
- Never use the unit for more than 1 minute without spraying water.

5. CLEANING AND MAINTENANCE

- Use only cleaning products specific for pressure washers.
- The machine must be switched off and disconnected from the mains for cleaning or
maintenance.
- Do not store the pressure washer outdoors or where it can freeze, the pump could be
severely damaged.
- The anti-impurities filter of the water inlet must be regularly checked to prevent blockages
in the water supply to the pump. Fig. 8
Cleaning the nozzle
A clogged or partially clogged nozzle can significantly reduce water output and cause
intermittent jetting. To clean the nozzle:
1. Turn off and unplug the unit.
2. Disconnect the water supply. Press the trigger 2 or 3 times to release the pressure trapped
in the hose.
3. Remove the lance from the trigger gun.
76
HYDROBOOST 3200 TOTALCLEAN