Cleaning And Maintenance - cecotec HidroBoost 2400 Home&Car Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 6
NOTE: Rinse the soap bottle with clear water after each use.
4. Final rinse
Start the final rinse at the bottom and work upward. Make sure the surface is thoroughly
rinsed and that al dirt is removed.
5. Shut down
Make sure all soap is flushed from the system.
Turn the motor off.
Turn the water supply off.
Once the power and water supply are turned off, press the trigger to depressurize the
device.
WARNING:
Do not turn the water supply off before turning the motor off. Serious damage could occur
to the pump and or motor.
Do not disconnect the high-pressure hose from the machine while the device is
pressurized. To depressurize, turn motor off, turn water supply off and squeeze gun
trigger 2-3 times.
TIPS FOR EXTENDING THE PRODUCT'S SERVICE LIFE
Never operate unit without water.
Do not use the device with hot water.
Before adjusting the pulverizing nozzle's pressure (high-to-low or low-to-high) release
trigger.
Never operate unit for more than one minute without spraying water.

5. CLEANING AND MAINTENANCE

Use specific soaps or cleaning agents for pressures washers.
The machine shall be disconnected from its power source by removing the plug from the
socket-outlet during cleaning or maintenance.
Do not store the pressure washer outdoors or where it could freeze. The pump could be
seriously damaged.
ENGLISH
Fig. 3
HIDROBOOST 2400 HOME&CAR
29
Tabla de contenido
loading

Tabla de contenido