Idiomas disponibles
Idiomas disponibles
CLEANING
AND RE=INSTALLING
HEPA=TYPE
FILTER cont.
5. Clean HEPA-Type filter by vacuuming entire surface area of filter using a
soft brush attachment from an upright or canister household vacuum.
NOTE: THIS FILTER IS NOT WASHABLE.
USING LIQUIDS TO CLEAN
HEPA-Type FILTER WILL DESTROY IT.
6. Place HEPA-Type filter back into air cleaner. Make sure the pleated side of
the filter is facing up.
7. Place intake grille back into air cleaner so that the bottom tabs engage into
the slots at the base of the unit
8. Gently push the intake grille forward until it snaps in place.
9. Plug the air cleaner back into a properly grounded 3-prong outlet.
10. Press the power button ON
11. Press and hold Filter Change/Clean
Reset button (see Fig. 2C) for up to
10 seconds to reset it.
REPLACING
THE PRE=FILTER
When the Change Pre-Filter Indicator Light (See Fig. 2B) lights up, it is time
to replace the charcoal pre-filter.
1. Turn the air cleaner OFF and unplug it from the
Intake Grille
power outlet.
2. Carefully lay the unit down on a flat surface
with the intake grille (rear of the air cleaner)
facing up. (See Fig. 3.)
3. Gently pull the release tabs on each side on
the intake grille up for removal.
4. Turn the intake grille around and place on a flat
surface so that the entire surface of the pre-
filter is visible.
5. Pre-filter is attached to four adhesive pads on
the interior of the intake grille. Detach pre-filter
and discard it. (See Fig. 4.)
Adhesive
6. Wipe off the outside and inside of the intake
grille with a soft, damp cloth to remove any
visible dust.
7. Remove and discard any plastic protective wrapping from the new pre-
filter.
8. With the adhesive pads visible, lay pre-filter inside intake grille and gently
push down to attach.
9. Place intake grille back into air cleaner so that the bottom tabs engage into
the slots at the base of the unit.
10. Gently push the intake grille forward until it snaps in place.
11. Plug the air cleaner back into a properly grounded 3-prong outlet.
12. Press the power button ON.
13. Press and hold Filter Change/Clean
Reset button (see Fig. 2C) for up to
10 seconds to reset it.
Fig. 4
Pads
