Idiomas disponibles
Idiomas disponibles
HOW TO SET THE SKID HEIGHT
Your snow thrower is equipped with
height adjust skids on the outside of the
auger housing.
To adjust the skid
height for different conditions,
see To
Adjust Skid Height paragraph in the
Service And Adjustment
section.
HOW TO SET THE LENGTH OF THE CABLES
The cables were adjusted at the factory
and no adjustments
should be neces-
sary. However, after the handles are put
in the operating position, the cables can
be too tight or too loose. If an adjust-
ment is necessary, see "How To Check
And Adjust The Cables" in the Service
And Adjustment
section.
_,- CHECKLIST
Before you operate your new snow
thrower, to ensure that you receive the
best performance and satisfaction from
this quality product, please review the
following checklist:
_" All assembly instructions have been
completed.
,_" The discharge chute rotates freely.
No remaining loose parts in carton.
_" Check the fasteners.
Make sure all
fasteners
are tight.
_" On electric start models, the unit was
shipped with the starter cord plugged
into the engine. Before operating, un-
plug the starter cord from the engine.
While learning how to use your snow
thrower, pay extra attention to the fol-
lowing important items:
Engine oil is at proper level.
Make sure gas tank is filled properly
with clean, fresh, unleaded gasoline.
Become
familiar
with all
controls-
their location and function.
Operate
controls before starting engine.
9
