Idiomas disponibles
Idiomas disponibles
NOTE:
If the cables
have become
dis-
connected
form the drive levers,
rein-
stall the cables
as shown
in Figure
4.
"z" Fitting
Lever
NOTE:
If the cables have become dis-
connected,
connect cables as shown in
Figure 7.
Traction Drive Cable
Auger Drive Cable
Control Cable
Figure 4
6,
Install the fasteners
that were re-
moved
in step 4. DO NOT tighten
until all bolts are in place.
Left Side Of
3/8" Nylon
Eye Bolt
Figure 5
7. Attach the crank rod to the universal
joint assembly
with the hair pin. See
Figure 6.
8.
Tighten nut on eye bolt, Make sure
eye bolt is properly aligned and the
crank can freely rotate.
9. Tighten all handle and panel bolts.
Figure 7
HOW TO ASSEMBLE
THE CHUTE DEFLECTOR
1. Remove the carriage bolt. See
Figure 8.
2.
Raise the chute deflector
into op-
erating position.
3.
Fasten chute deflector to flange
with carriage bolt. Make sure to
install with head of carriage bolt on
the inside of the flange.
4.
Fasten with washer and Iocknut.
5. Tighten Iocknut securely.
NOTE: Make sure all carriage
bolts in flange are tight. DO NOT
OVERTIGHTEN.
Nut
Crank Rod
Was
Carriage Bolt
Flange
Figure 8
Universal
Figure 6
8
