Idiomas disponibles
Idiomas disponibles
5. Assembling the Cymbal Stand
Fig. 5-1
Fig. 5-2
6. Adjusting the position of the Drum Set and Stands
After opening the tripod base and raising the lower
Cymbal Mate
pipe, insert the middle and upper pipes to complete
assemble the cymbal stand. Set the cymbal in between
the two felts of the cymbal tilter as shown in Fig. 5-1.
Felt
In addition, the boom cymbal stand is designed with a
"convertible tilter", allowing it to be used as a straight
stand by storing the boom arm in the upper pipe, as
Cymbal
shown in Fig. 5-2.
Bottom Sleeve
IMPORTANT
* TAMA attaches the plastic cymbal sleeve to the tilter so the
* Depending on the confi guration, the boom stand may not be
Finally, refer to the image of the drum set on the table
of contents page, install each stand in the preferred
position, and adjust the height and angle of each
instrument as desired. With the entire drum set in
playing position, check that each of the T-bolts and
T-nuts are tightened securely.
If a part is worn or damaged, it can be replaced.
A parts catalog is available on TAMA's offi cial website
(https://www.tama.com) .
This assembly manual is current as of March 2022.
Please note that the specifications are subject to
change without notice due to product improvement.
cymbal does not have direct contact with the metal tilter.
Over time, the plastic sleeves can become worn, so make
sure to consistently check their condition in order to prevent
damage to the cymbal. The cymbal sleeve is reversible, so
the bottom side can be used once the top side is worn.
included in the drum set you purchased.
TSIMP22C
9
