Idiomas disponibles
Idiomas disponibles
Comply with the national regulations for working at heights.
As drop arrester for this product, use only a combination of the Hilti retaining strap #2293133 and the Hilti
tool tether #2261970.
▶ Secure the retaining strap to the installation openings for accessories. Check that it holds securely.
▶ Secure one carabiner of the tool tether to the retaining strap and secure the second carabiner to a
load-bearing structure. Check that both carabiners hold securely.
Comply with the operating instructions of the Hilti retaining strap and those of the Hilti tool tether.
5.8
Setting the torque
▶ Set the desired torque.
6
Operation
Observe the safety instructions and warnings in this documentation and on the product.
6.1
Switching on
The metal construction screwdriver starts running as soon as it is pressed lightly against the working
surface. The running speed can be controlled smoothly right up to maximum speed by varying how
far the control switch is pressed in.
▶ Switch the tool on.
6.2
Switching on in sustained operating mode
The lockbutton can be pressed in while the control switch is pressed. The metal construction
screwdriver then runs in sustained operating mode. The lockbutton makes the tool less tiring to use
as the control switch does not have to be constantly pressed.
▶ Switch on in sustained operating mode.
6.3
Switching off after sustained operation
In order to be able to switch off from sustained operating mode quickly at any time, keep your hand
close to the control switch. Pressing the control switch again causes the lockbutton to jump back into
its original position.
▶ Switch off after sustained operation.
6.4
Removing screws
Remove the depth gauge or screw guide, if fitted. Set the forward / reverse switch to the "Reverse"
position.
▶ Remove the screws.
7
Care and maintenance
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
*2383934*
5
7
2383934
6
English
23
