Hilti Nuron ST 2000-22 Manual De Instrucciones Original página 25

▶ If the battery is too hot to touch, it may be defective. Put the battery in a place where it is clearly visible
and where there is no risk of fire, at an adequate distance from flammable materials. Allow the battery to
cool down. If it is still too hot to touch after an hour, the battery is faulty. Consult Hilti Service or read the
document entitled "Instructions on safety and use for Hilti Li-ion batteries".
Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
Read the instructions on safety and use of Hilti Li-ion batteries that you can access by scanning
the QR code at the end of these operating instructions.
3 Description
3.1 Product overview
3.2 Intended use
The product described is a hand-held cordless screwdriver for fastening profile metal sheets, metal sheets
and sandwich panels in metal construction.
• For this product, use only Hilti Nuron lithium-ion batteries of the B 22 series. For optimum performance,
Hilti recommends the batteries stated in the table at the end of these operating instructions for this
product.
• For these batteries, use only Hilti chargers of the type series stated in the table at the end of these
operating instructions.
3.3 Overloading and overheating protection
The product is protected against overloading and overheating by an automatic cut-out. After overheating,
when the control switch is pressed to restart the product there may be a delay before the product restarts.
3.4 Items supplied
Metal construction screwdriver, depth gauge, bit holder, belt hook, operating instructions
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
3.5 Status indicators of the Li­ion battery
Hilti Nuron Li-ion batteries can indicate state of charge, fault messages and the battery's state of health.
*2383934*
1
2383934
Tool holder
@
Interface to depth gauge (ST-DG) and screw
;
guide (ST-SG)
Torque adjustment
=
Interface to stand-up tool (SDT)
%
Air intake
&
Grip
(
Air discharge
)
Lockbutton
+
Installation opening for accessories
§
Battery
/
Battery status indicator
:
Battery release button
∙
Work-area light
$
Control switch
£
Forward/reverse switch / transport lock
|
Depth gauge adjustment (optional)
¡
Depth gauge (optional)
Q
English 19