Troubleshooting - henkelman DT 60 Manual De Instrucciones

Troubleshooting

Problem
The machine doesn't
function.
(no power light or display)
The machine doesn't heat
up.
The power light is on.
Pump is running after
completing the total cycle.
The platform is not going
down.
The platform is only going
down when start button is
pushed.
The platform is not rising.  The total weight of the products is
Machine is heating up
despite absent of water.
Cause
 The plug is not connected.
 The fuse(s) from the main power
supply are burned.
 The automatic fuse in the electrical
cabinet is switched off.
 Main switch (S1) is switched off.
 Insufficient level of water.
 The temperature value is too low.
 Temperature control is malfunction.
 Micro switch (S4) has a short cut.
 Start button (S3) has a short cut.
 Rotating direction of the pump is
wrong.
 The start switch is disconnected or
broken.
 Thermal overload pump is
activated.
 Micro switch (S4) is malfunctioning. 
too much.
 Thermal overload is activated.
 Time relay is malfunction.
 Insufficient amount of oil.
 Floating device is blocked in top
position.
Solution

Check the Plug on a
proper connection.

Replace the fuse(s).

Check the automatic fuse,
and reset it.

Switch on the main switch
on the backside of the
machine.

Add water to the
recommended level. Max.
level: 10 cm under the
edge. Preference un-
chalked water.

Increase the temperature.

Check the temperature
control.

Check the proper function
and the correct position.

Check the proper function
and the correct position.

Interchange two phases.

Check the start switch.

Check the setting. The
used thermal overload
will activate automatically
after cooling down.
Check the micro switch.
(S4)

Switch of the machine. Let
the water cool down or
drain it. Take out the
product and start again.

Check the setting.

Check the time relay.

Check the oil level.

Check floating device. If
necessary clean it.
13