Idiomas disponibles
Idiomas disponibles
•
For PG 280 Part set - outer row. Effective
concentrated surface removal.
•
For PG 280 S Full set - outer row. Effective
concentrated surface removal.
•
For PG 280 S Part set - outer row. Very aggressive
concentrated surface removal.
Select the correct resin bond diamond for your operation
This table includes the basic configurations for the resin
bonded diamond segments.
Surface
To polish terazzo or stone tiles
To make a new surface on terazzo
or stone tiles
To polish the surface of concrete
floors - Hard concrete
2112 - 002 - 24.10.2023
Surface
To polish the surface of concrete
floors - Medium concrete
To polish the surface of concrete
floors - Soft concrete
To do before you operate the product
1. Read the operator's manual carefully and make sure
2. Do daily maintenance. Refer to
3. Make sure that the product is assembled correctly
4. Put the product on the work area.
5. Make sure that there are diamond tools on the tool
6. Connect the dust extractor to the product. Refer to
7. Adjust the handlebar to set the necessary work
8. Make sure that the motor cable is connected to the
9. Connect the power plug of the product into the mains
10. Make sure that you know in which direction the
11. For PG 280 turn the emergency stop button
To do a check of the direction of rotation of the
motor PG 280
1. Start the product. Refer to
2. After some seconds, stop the product. Refer to
Full set
Half
- outer
set -
row
outer
row
X
X
X
that you understand the instructions.
on page 15 .
and is not damaged.
plate and that they are tightly attached.
To connect a dust extractor on page 15 .
height.
electrical enclosure before the product is connected
to an electrical socket.
outlet.
motor rotates.
clockwise to make sure that it is disengaged.
page 12 .
stop the product on page 12 .
Full set
Half
- outer
set -
row
outer
row
X
X
Daily maintenance
To start the product on
To
11
