Idiomas disponibles
Idiomas disponibles
10
Remote Control Unit Preparation
Battery Installation
O Remove the battery holder.
Back side
Lithium battery
Pull the holder by the position B while pushing
(included)
position A in the direction indicated by the arrow.
0 Install the battery on the battery holder.
Set a new battery properly with its (+) side facing
1 A
up as shown in the figure.
© Insert the battery holder.
Push the battery holder back into its original
Battery Notes
Remove and dispose of an old battery immediately.
Position A
Battery Information:
e Battery Type: Panasonic lithium battery (CR2025) (Included)
e Battery Life: Approximately 6 months with normal use (at room temperature)
Caution: Improper use of batteries may cause overheating, an explosion, ignition, resulting in injury or a fire. Battery
leakage may damage the unit.
e Do not disassemble or short the battery. Do not throw a battery into a fire.
e Keep batteries away from children to avoid the risk of accidents.
e Be careful to observe proper local disposal rules when you dispose of batteries.
Control Reference Guide
Buttons of the remote control function in the same way as the controls on the main unit of the reference page.
Point the remote control unit at the main unit's sensor (REMOTE).
| [
rem control
Mute
SL:
pages 11, 12)
Scan
Repeat
RAND
SCAN
REP
Folder/Disc Selection
(=> pages 20,22)
4
en
Band/Set/Pause
(=> pages 14, 15, 17, 20, 22)
CQ-DP171U
Display
(=> pages 11, 13, 16, 17, 19, 20, 22)
[0] to [9]
(=> pages 15, 17, 20, 22)
