Idiomas disponibles
Idiomas disponibles
USER MANUAL
NOTES
1.
If the SPEAKER ATTN switch is set to BYPASS and no speaker is connected to the SPK OUT, a resistor is
automatically switched into the amplifier path to protect an amplifier connected to the AMP IN.
2.
If the SPEAKER ATTN switch is set to BYPASS, no power measurement is possible in the INPUT LEVEL circuit.
This means that no input signal level is displayed even though a signal is present at AMP IN.
3.
If the SPEAKER ATTN switch is set to FULL ATTN, no power measurement is possible in the OUTPUT LEVEL
circuit, as there is no signal at the SPK OUT loudspeaker output. Consequently, the OUTPUT LEVEL level
indicator shows no signal in this case.
4.
If the Supreme Soaker is in standby mode or disconnected from the power supply and no speaker
is connected to the SPK OUT, a resistor is automatically switched into the amplifier path to protect an
amplifier connected to the AMP IN.
5.
If no speaker is connected to SPK OUT, set SPEAKER ATTN to FULL ATTN so that the exact impedance set
using the AMP LOAD switch is available.
6.
Never switch SPEAKER ATTN, SPEAKER TONE and AMP LOAD under load (while playing the guitar).
7.
LINE OUT, RE-AMP OUT and PHONES can quickly distort at high frequencies if LINE EQ and SPEAKER TONE
are set to BYPASS. Make sure that there is always at least one filter for the loudspeaker simulation in the
signal path. In a classic setup with an amplifier and loudspeaker, high-frequency distortion cannot
occur because a guitar loudspeaker cannot reproduce high frequencies at all.
8.
If SPEAKER ATTN is set to FULL ATTN and a speaker is connected to the SPK OUT output, the impedance
at the AMP IN amplifier input is always 32 ohms. To ensure that the exact impedance set using the AMP
LOAD switch is available, disconnect the loudspeaker from the SPK OUT loudspeaker output.
9.
The power measurement of the OUTPUT LEVEL circuit is only correct if the AMP LOAD setting and the
impedance of the connected loudspeaker match.
10. If there is no signal at the LINE OUT line output, check these three settings and change them if
necessary:
A. Front: SPEAKER ATTN is set to FULL ATTN and AMP TO LINE OUT is set to POST.
B. Front: BLEND of LINE OUT is fully set to MIC and no microphone is connected or 48V phantom
power is switched off, but is required for the connected microphone.
C. Rear: SEND of FX LOOP is plugged in, but RETURN is not and FX LOOP of LINE OUT is set to WET
(open serial FX loop).
EN
15
