Idiomas disponibles
Idiomas disponibles
Proper anchoring is essential to the safety and performance of this product. We recommend using Aquaglide
mooring lines and weight recommendations as a starting point. Weight recommendations are intended to
keep products in place during a normal range of weather conditions faced by most aquaparks. Even in so-
called light-wind areas, storms, squalls and other extreme weather events can happen quickly. If improperly
anchored, product can move and/or float away. Aquaglide is not responsible for damage, injury or loss due to
improper anchoring.
Open Water: (General guidelines - not intended to replace need for professional installation)
1. Place product in an area protected from wind and boat traffic. Confirm allowances for stated minimum
water depth, safe distance away from hard objects and vertical clearance requirements.
2. Consider prevailing conditions such as wind, waves and other environmental factors in positioning this
item. Inflatable items can be unstable in strong winds. Slide faces are best positioned toward a breeze, not
across it. Check water and seabed for sharp or dangerous objects.
3. Keep product a safe distance from docks, boats, boat lifts, and any other structures. To prevent potential
damage to product, injury or death, NEVER tie the product to a dock.
4. Use one vertical mooring line for each anchor ring with an appropriate weight anchor, ground screw, or
earth anchor at base. For exposed anchorages or water depth greater than 20ft. (6m), bridles connecting two
rings to one mooring line may be preferable.
5. Anchor weight recommendations are based on the maximum potential wind loads generated by each
item at a wind speed of 26 knots (48 km/h, 30 mph). Weight recommendations are based on the apparent
weight of concrete mooring blocks in either salt or fresh water. If significantly stronger winds are forecast, we
recommend partially deflating larger items or removing items from the water for storage.Sites with potential
for extreme weather, strong tides, currents, winds and/ or swell should consider using up to 50% additional
weight or holding power.
6. Install anchors and mooring lines before inflating this product.
Anchor Details – Ridgeway 10
Anchor rings on product
Recommended anchor qty
2-Way Bridle?
Recommended weight/ anchor
Recommended total anchor weight
Commercial Pool:
1. Product placement in commercial pool should be checked carefully in advance to confirm allowances for
the stated minimum water depth, safe distance away from hard objects (pool edge) and vertical clearance
requirements. Most residential pools cannot meet these requirements.
2. Pool moorings typically use a minimum of 4 horizontal mooring lines made from heavy duty elastic. Addi-
tional horizontal moorings should be added to increase stability and as necessary for larger product groups.
3. Horizontal Moorings are usually attached to pool anchor eyes, such as those used to secure lane buoy
lines. Adjust mooring lines to keep product(s) under tension at all times.
8
ANCHORING
ANCHORING
Qty/ Weight lb (kg)
4
4
No
250lb (100kg)
1000lb (400kg)
www.aquaglide.com
