Idiomas disponibles
Idiomas disponibles
SAW BLADES
Even thebest s awblades w ill
not cut efficientlyif they are not kept clean, sharp and
properlyset. Using dull bladeswill place a heavy load on your saw and increase the
danger of kickback.Keep extra blades on hand, so sharp blades are always available.
Gum and wood pitchhardened on your blades will slowyour saw down. Use gum
and pitch remover, hot water or keroseneto remove these accumulations,
DO NOT use gasoline.
I /_, WARNING:
This Twin Cutter saw uses specially designed 5-in. blades
I
and no other typos or sizes of blades shouldever be used. Other typos and sizes of
blados will not operate safely in this saw and could result in serious personal injury.
To order extra blades or to replace the blades that came with the saw, see page 21
of this manual for ordering instructions. To install new blades onto to your saw see
the special instructions on pages 17 to 19 of this manual for proper removal and
insta]lation of blades.
BLADE GUARD SYSTEM
The lower blade guard, attached to your saw, is there for your protection and
safety. It should NEVER be altered for any reason. If It becomes damaged or
begins to return slowly or sluggishly. DO NOT operate your saw until the
problem has been corrected or the damaged part has been replaced. ALWAYS
leave the guard in its correct operating position when using the saw.
./K DANGER:
When sawingthrough a
workpiece, the lower blade guard does not
cover the blade on the underside of the
workpiece.Since the blade is exposed on the
underside of the workpiece,ALWAYS keep
your hands and fingers away from the cutting
area (see Fig. 2). Any part of your body
coming in contact with the moving blade will
result in serious injury.
Lower Blade Guard is in UP position when
making a cut. Blades are exposed on underside
of workpiece.
\ Fig.2
Z_ WARNING:
NEVER use the saw when the guard isnot operatingproperly.
The guard shouldbe checkedfor correctoperationbeforeeach use. If you drop your
saw,checkthe lowerblade guard for damage beforeusing,
NOTE: The guard isoperatingproperlywhen it moves freely and then readily
returnsto the closed position.If, for any reason,your lowerbladeguard does not
closefreely, take it to your nearest Sears Repair Centerfor service beforeusingit.
10
