Idiomas disponibles
Idiomas disponibles
Charging (Fig. 2)
1
Plug the AC adaptor into the main body and the
household outlet.
• Check the charge status lamp (
It turns off after charging is completed.
• Charging is completed after approx. 1 hour.
2
Disconnect the power plug after charging is completed.
• Charging is required when the recharge
lamp blinks.
• The appliance can be used for
approximately 5 minutes after the
recharge lamp blinks.
<How to check that charging is completed>
Insert the main body again after removing it from the AC adaptor.
If the charge status lamp glows and then turns off after
5 seconds, charging is completed.
► Notes
• Recommended ambient temperature for charging is
10 °C – 35 °C. It may take longer to charge, or the charge
status lamp will blink quickly and the battery may fail to
charge properly in extremely high or low temperatures.
• 1 full charge will provide approximately 50 minutes of
continuous operation. (Based on dry using at 20 °C – 30 °C)
The operating time may differ depending on the frequency of
use and the operating method.
• When charging the appliance for the first time or when it has
not been in use for more than 6 months, the charging time
may change or the charge status lamp (
a few minutes. It will eventually glow if kept connected.
10
) glows.
) may not glow for
• If there is noise from the radio or other sources while using
or charging the appliance, move to a different location to use
the appliance.
• The battery will deteriorate if not used for over 6 months, so
make sure to perform a full charge at least once every 6 months.
AC operation
If you connect the AC adaptor to the appliance in the same
way as for charging, and turn on the power, you can use it.
• The charge status lamp glows when using AC operation.
• If the remaining battery is too low, the blades may move
slowly or stop, even with the AC operation. In this case,
charge the battery for 1 minute or more.
• The battery will be discharged, even with the AC operation.
How to use
• Check that the blades are not damaged or deformed before use.
• Apply the lubrication oil to the blade before and after each
use. (See page 11.)
• The appliance may not operate in an ambient temperature
lower than approximately 5 °C.
• After use, turn it off and clean it.
1
Set the trimming height.
2
Turn on the power.
► About setting the trimming height
For a trimming height of 0.8 mm to
2.0 mm, turn the dial to the desired
height.
Use an attachment for a trimming
height higher than 3 mm or more.
0.8
1.1
1.4
1.7
1.4
2.0
