GE PVM1790 Instrucciones De Instalación página 7

Installation Instructions
TOOLS YOU WILL NEED
——— Ruler or tape measure
. and straight edge
#1 and #2 Phillips screwdriver Pencil OF Carpenter square
Se,
(optional)
_ Cd"
of betarhnielaielaerlontednialatelalabalabebatnteialsedal
2; SS.
Tin snips (for cutting
damper, if required}
Scissors
. 1 SAM TA.
(to cut template, if necessary) Electric drill with "5", Ae",
2" and 9" drill bits Filler blocks or scrap
wood pieces, if needed
for top cabinet spacing
{used on recessed bottom
Sy cabinet installations only}
Gloves
Saw (saber, hole or keyhole} Stud finder or Hammer (optional)
G ee >
We (=| :
Safety goggles
Level
Duct and masking tape
¢ The space between the cabinets must be 30" wide
and free of obstructions.
Ly e If the space between the cabinets is greater than
som | Bottom edge of 30", a Filler Panel Kit may be used to fillin the gap
-- cabinet needs to between the oven and the cabinets. Your Owner's
be 30" or more Manual contains the kit number for your model.
from the cooking
surface @ This ovenis for installation over ranges up to
36" wide.
¢ If you are going to vent your oven to the outside,
see Hood Exhaust Section for exhaust duct
preparation.
66" or more |< SNe ¢ When installing the oven beneath smooth, flat
from the floor cabinets, be careful to follow the instructions
to the top of on the top cabinet template for power cord
the oven clearance.
¢ Maximum cabinet depth above and beside the unit
is 13".
* For models with top venting holes: Do not allow
cabinetry or other objects to block the airflow of the
vent.
¢ The product should not be installed over any
cooktop or range with a combined BTU greater
than 60000 BTU.
13" max.
Jn Backsplash