Hilti SID 8-A22 Manual De Instrucciones Original página 22

Fitting the belt hook (optional)
WARNING
Risk of injury! Hazard presented by a falling power tool
▶ A falling power tool may present a risk of injury to yourself and others. Check that the
belt hook is fitted securely before beginning work.
Note
The belt hook allows the power tool to be attached to a belt worn by the operator. The
belt hook can be fitted to allow attachment on the left or right side of the body.
6 Care, maintenance, transport and storage
6.1 Care and maintenance of the tool
WARNING
Electrical hazards! Improper repairs to electrical parts may lead to serious injuries.
▶ Electrical parts may be repaired only by trained electrical specialists.
▶ Keep the tool, especially its grip surfaces, clean and free from oil and grease. Do not use cleaning
agents containing silicone.
▶ Never operate the impact screwdriver when the cooling air slots are blocked. Clean the cooling air slots
carefully using a dry brush. Do not permit foreign objects to enter the interior of the tool.
▶ Clean the outside of the tool at regular intervals with a slightly damp cloth. Do not use a spray, steam
pressure cleaning equipment or running water for cleaning.
6.2 Care of the Li-ion battery
▶ Keep the battery clean and free from oil and grease. Do not use cleaning agents containing
silicone.
▶ Clean the outer surfaces with a slightly damp cloth at regular intervals.
▶ Do not allow moisture to enter the interior.
▶ Charge the batteries using the Hilti chargers approved for use with Li-ion batteries.
6.3 Transport and storage
WARNING
Risk of fire! Risk of short circuiting
▶ To avoid short circuits and associated heat generation, Li-ion batteries should never be stored or
transported in loose, bulk form and without protective measures.
▶ Pull the battery out of its locked position and into the first engagement position.
▶ Observe the nationally and internationally applicable transport regulations when shipping batteries by
road, rail, sea or air.
Note
Ideally, the battery should be stored in a fully-charged state in a dry place that is as cool as
possible. Storing the battery in places subject to high ambient temperatures (e.g. at a window) has
an adverse effect on battery life and increases the rate of self-discharge.
If the battery no longer reaches full charge, it may have lost capacity due to aging or overstressing.
It is still possible to work with this battery. You should, however, soon replace the battery with a
new one.
7 Troubleshooting
If the fault you are experiencing is not listed or the recommended action to be taken does not successfully
solve the problem, please remove the battery and return the power tool to Hilti Service.
Printed: 20.05.2015 | Doc-Nr: PUB / 5230112 / 000 / 00
7
17