Hilti SID 8-A22 Manual De Instrucciones Original página 20

3.3 Items supplied
Impact screwdriver, operating instructions.
Note
Approved accessories and consumables can be found at your Hilti Center or at www.hilti.com.
3.4 Li­ion battery display
When the Li-ion battery is in use, the charge status can be displayed by tapping one of the battery release
buttons.
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED blinks, the power tool is ready for use.
1 LED blinks, the power tool is not ready for use.
4 LEDs blink, the power tool is not ready for use.
Note
Indication of the charge status is not possible while the power tool is in operation or immediately
after operation. If the battery charge status LEDs flash, please refer to the information given in the
Troubleshooting section.
4 Technical data
4.1 Impact screwdriver
Rated voltage
Weight in accordance with EPTA-Procedure 01/2003
Rated speed under no load
Torque
4.2 Noise information and vibration values determined in accordance with EN 60745
The sound pressure and vibration values given in these instructions have been measured in accordance with
a standardized test and may be used to compare one electric tool with another. They may be used for a
preliminary assessment of exposure.
The data given represents the main applications of the electric tool. However, if the electric tool is used for
different applications, with different accessory tools, or is poorly maintained, the data may vary. This may
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the power tool is switched
off, or when it is running but not actually being used for a job. This may significantly reduce exposure over
the total working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration, for
example: maintaining the power tool and accessory tools, keeping the hands warm, organization of work
patterns.
4.2.1 Noise information in accordance with EN 60745
Sound (power) level (L
Uncertainty for the sound power level (K
Emission sound pressure level (L
Uncertainty for the sound pressure level (K
Printed: 20.05.2015 | Doc-Nr: PUB / 5230112 / 000 / 00
)
WA
)
WA
)
pA
)
pA
Meaning
• Charge status: 75 % to 100 %
• Charge status: 50 % to 75 %
• Charge status: 25 % to 50 %
• Charge status: 10 % to 25 %
• Charge status: < 10 %
• The battery has overheated.
• The power tool is overloaded or has overheated.
21.6 V
3.1 kg
2,200 rpm
500 N⋅m
106 dB(A)
3 dB(A)
95 dB(A)
3 dB(A)
DC
15