Tabla de contenido
Idiomas disponibles
Idiomas disponibles
The wind temperature and wind volume
can be adjusted in two stages depending
on which way the switch is set.
Switch [I] position:
660 ºF (350 ºC) (wind volume 0.25 m
Switch [II] position:
930 ºF (500 ºC) (wind volume 0.5 m
Press the quick cooling button and press the
switch to blow warm air at approximately
50 degrees Celsius for each of the switch's
wind volumes.
This is used to quickly cool material that is
heat-warping and to cool the nozzle when it
reaches high temperatures after using the
tool.
Switch
2. Using the Hook (Fig.3.)
CAUTION
When pointing the tool upward to work,
make sure that it is placed on a stable
block that does not tilt.
Do not hang the tool from your wrist or
waist when moving around with the
nozzle still hot.
Support the tool firmly when pointing the
heat-wind release nozzle upward.
Also, it is possible to suspend the tool from
a wrist, etc., with a cord to prevent it from
being dropped when working in high
locations, etc.
Quick cooling
button
Fig. 2
Hook
3
)
3
)
3. Attaching the Nozzle (Fig.4.)
CAUTION
The nozzle is extremely hot immediately
after use, so do not touch it.
NOTE
Make sure you do not drop the nozzle.
Replace the nozzle for a type that is suited to
the job in hand.
Insert the nozzle supplied firmly into the hot
wind release nozzle until it can go no further.
Nozzle (Plane)
4. Temperature Settings
WARNING
Do not use the tool in the vicinity of
volatile substances (thinner, gasoline,
etc.)
Do not bring the hot wind release nozzle
in close contact with your hands or face
during use.
The nozzle is extremely hot immediately
after use, so do not touch it.
Set the temperature in consideration of the
article to be heated.
Also, pay attention to the surrounding
material that will be heated at the same time.
First of all, apply the hot wind from a distance
while checking that there are no changes in
the article being heated, and then move it
closer until it reaches an appropriate
distance.
English
Fig. 3
Hot wind release nozzle
Fig. 4
9
Tabla de contenido
